Versatile Engine Management Systems / / ACMV, LLC
  Top » Catalog » Engine Management » Spare Parts » Testing » My Account  |  Cart Contents  |  Checkout   
Engine Management-> (157)
  Adapter cables (12)
  Fuel delivery (6)
  iButton security (2)
  Ignition (5)
  Pneumatic parts (7)
  Sensors (27)
  Universal Harness (3)
  Connectors (16)
  Accessories (7)
  Wiring Accessories (13)
  Upgrade Parts-> (13)
  Spare Parts-> (35)
    Case (11)
    Testing (16)
What's New? more
Quick Find
Use keywords to find the product you are looking for.
Advanced Search
Shipping & Returns
Privacy Notice
Ether Cryptocurrency
Bitcoin Cryptocurrency
Conditions of Use
Contact Us
inductor 1.23EUR

note: a 470 Ohm 0.6W resistor also included
220 uH for RPM output "inductive pullup" (0.7A 9.5mm x 12.5mm marked 221)
If your RPM gauge originally got the input signal directly from the primary side of the ignition transformer (common for cars that originally had distributor ignition), or you know that the RPM gauge likes high voltage. Since 1989 most gauges are fine with the recommended EC36pin4 (p259/0) pulled up (to +12V with 1k .. 10k), but for example on old (older than 1989 ?) BMW was NOT sufficient to drive the tachometer gauge:
Take a free ignition output (IGBT based, not logiclevel !) and connect it to the input of the RPM gauge. Beware that injector FET or other output is not suitable, would be ruined immediately!!!.
We used EC36pin10, that is i259/7 as seen on GenBoard/Manual/DigitalOut/Table), configured tach_channel accordingly and used an "inductive pullup" to (switched) +12V made from a 470 Ohm and 220uH connected in series.
The inductor will make high enough voltage (up to appr 380..400V) to satisfy the RPM gauge. Don't touch it because either you or your family will be unhappy. The 470 Ohm resistor is to limit current if the output is enabled for too long due to misconfiguration or very low RPM.
Note: The 220uH value is NOT for the onboard "main supply filter" (could be overloaded by the 4 stepper outputs if total draw from +12V side exceeds 0.5A )

1.5 uH (5.4A 9.5mm x 12.5mm marked 1.5) Probably only useful if you build your controller yourself and lost the "supply filter" inductor from the rescue-kit. 1.5uH value is NOT for the "RPM output inductive pullup".

Available Options:
For more information, please visit this products webpage.
This product was added to our catalog on Sunday 12 February, 2006.
Customers who bought this product also purchased
VAG active COP connector
VAG active COP connector
LED - superbright 10mm
LED - superbright 10mm
small DENSO 30A relay
small DENSO 30A relay
Tesa tape
Tesa tape
USB to RS232 adapter FTDI
USB to RS232 adapter FTDI
Shopping Cart more
0 items
Notifications more
NotificationsNotify me of updates to inductor
Tell A Friend
Tell someone you know about this product.
Reviews more
Write ReviewWrite a review on this product!
English Deutsch

Copyright © 2018 VEMS Shop
Powered by osCommerce