5-wire LSU4 Wideband oxygen sensor with 2x3=6 pin (U-shaped) connector and M18x1.5 thread.
Replacement sensor for VEMS Round WBO2 and EGT gauge.
Note: LSU4.9 sensor is recommended for VEMS Genboard V3.x (even where LSU4.2 was used earlier: old controllers only require a resistor internally or in the loom, and the smaller LSU4.9 connector, and selecting LSU4.9 in config: read the LSU4.9 related pdf).
Usually Bosch 0 258 007 057/058 (or 0 258 007 351 or 0 258 007 113/114 or 0 258 007 063/064 ) or compatible, the same sensor is available with different cable-length. Genuine Bosch again (earlier when Bosch could not deliver for months, there was a shortage of genuine Bosch sensors for 2 weeks, as was noted here). Choose the LSU4.9 sensor is recommended unless for replacement.
- "With connector=yes" means matching wideband connector,
- "With crimped wire" also includes wires with crimped receptacles.