LSU4.2 Wideband O2 sensor

99.95EUR


5-wire LSU4 Wideband oxygen sensor with 2x3=6 pin (U-shaped) connector and M18x1.5 thread.
Replacement sensor for VEMS Round WBO2 and EGT gauge.
Note: LSU4.9 sensor is recommended for VEMS Genboard V3.x (even where LSU4.2 was used earlier: old controllers only require a resistor internally or in the loom, and the smaller LSU4.9 connector, and selecting LSU4.9 in config: read the LSU4.9 related pdf).
Usually Bosch 0 258 007 057/058 (or 0 258 007 351 or 0 258 007 113/114 or 0 258 007 063/064 ) or compatible, the same sensor is available with different cable-length. Genuine Bosch as usual.
  • Sensors are sensitive to being dropped (especially onto hard floor).
  • Incorrect handling, wiring or configuration might result in permanent sensor damage. Wideband sensors are non-returnable. We do not sell restocked sensors (warranty and restocking does not apply to genuine Bosch wideband sensors ).
  • Bosch genuine sensors are tested by Bosch. We test and calibrate on explicite request.
  • For new installs the LSU4.9 sensor is recommended except for VEMS Round (traditional LSU4.2 type) WBO2 sensor replacement.
    • "With connector=yes" means matching wideband connector,
    • "With crimped wire" also includes wires with crimped receptacles.
  • Available Options